Kathy Ireland CF995BS01 Owner's Manual page 10

3. Ceiling Fan Assembly
3.16
Place the Ceiling Cover over the 10" Downrod.
Be sure the Ceiling Cover is oriented correctly
(Figure 16).
3.17
Route the Two Motor Wires through the Hanger Ball.
Reinstall the Hanger Ball (Figure 17) on the Downrod
as follows:
Position the Pin through the Two Holes in the Downrod
and align the Ball so the Pin is captured in the Groove
in the top of the Hanger Ball.
Pull the Hanger Ball up tight against the Pin and
securely tighten the Set Screw in the Hanger Ball.
NOTE: A loose set screw could create fan wobble.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the set screw securely tightened. Failure
to verify that the pin and set screw are properly
installed could result in the fan falling.
(continued)
10" DOWNROD
CEILING
COVER
Figure 16
PIN
10" DOWNROD
Figure 17
10
HANGER BALL
PHILLIPS HEAD
SET SCREW
ETL Model No.: CF995-1