Bluewavedx Tool Download; Setup For The Bluewavedx Tool; Updating Firmware Using The Bluewavedx Tool - JCM GEN2U Training Overwiev

GEN2U™ Printer
BLUEWAVE™DX DOWNLOAD
The JCM
BlueWave™DX Tool
Firmware on the GEN2U Printer. To do so, proceed as follows:
S
ETUP FOR THE
1. Within the BlueWaveDX Tool's
folder.
System
2. The Firmware files for the GEN2U Printer should be placed within the new
GEN2U System
NOTE: Sub-folders are not recognized.
U F
PDATING IRMWARE
1. Connect a standard
Tool's
USB Connector Type A
Update Port
2. Turn the BlueWaveDX Tool's Power Switch
3. When the
4. Press the
available GEN2U Firmware versions.
5. Press the
6. Press the
7. When the
(Figure 15 f) to return to the Main Menu
OR
Press the
f
e
Figure 15 BlueWaveDX Tool Primary Controls/GEN2U USB Update Port
Part No. 960-000192R_Rev. A
JCM® Training Overview
offers an alternate method for updating the
B W DX T
LUE AVE
folder.
U
SING THE
USB Male "A" to Male "B"
(Figure 15 b).
Firmware Update
and arrow keys (Figure 15 e) to scroll through the list of
UP DOWN
Button (Figure 15 d) to select the desired Firmware version.
OK
OK Button again to start the download.
Download Complete
Button (Figure 15 d) to download Firmware to another Printer.
OK
a
c
OOL
root directory, create a new
SD Card
B W
LUE AVE
cable from the BlueWaveDX
(Figure 15 a) to the GEN2U Printer's
ON
screen appears, press the
message is displayed, press the
d
1 6
DX T
OOL
(Figure 15 c).
Button (Figure 15 d).
OK
CLR
© 2017 JCM American Corporation
August, 2017
GEN2U
USB
Button
b