Advertisement
HR M
ANUAL
1.4
Components and accessories
Manual version 3.0 (10-10-2017)
1.4.1 Components supplied
Note:
n
The illustration shows the unit from above, whereby
the air exchange with the interior takes place on the
left side and the air exchange with the exterior takes
place on the right side.
•
Modules:
-
supply fan 1
-
extract air filter 2
-
extract fan 3
-
fresh air filter 4
-
recirculation damper 5
-
heat exchanger 6
-
heating/cooling element 7 (depending on the type of
unit)
•
Electronics module 8
•
Fastening material for linking the modules to each other.
1.4.2 Accessories
•
Flexible cuffs (attached to modules) 0
•
Air dampers to fresh air (attached to modules) !
•
Pressure switch over filters (attached to modules) @
•
Dirty filter warning lamp (during transport, this is stored in
the electronics module)
•
b-touch control panel
•
Sensor for control:
-
CO
sensor
2
1.4.3 Components not supplied
The following components required for installation must be
obtained from third parties:
•
threaded rods (M10)
•
mains power cable
•
control cable to building management system
•
drain pipe with trap for condensate drainage
en
I
NTRODUCTION
en-11
Advertisement
