Table of Contents
Advertisement
ETC Installation Guide
Contact and Demand Response Interfaces
Set Configuration Mode
The configuration mode switch allows selection between Basic and Custom
configurations of the interface. Basic is the factory default setting.
Basic
Basic configuration mode applies the following default behaviors:
Input Interface:
Inputs control Presets 1-4 respectively, using momentary input mode where
the closure behaves similar to an Echo Inspire station.
close / open event (push) executes a preset toggle
•
holding the contact closed (hold) performs a space raise
•
closing the closure twice (in rapid succession) performs a preset toggle
•
with 1/2 second override timing
Note:
Note:
ETC recommends a minimum of 500 ms between any input changes
to ensure transitions are reliably applied.
Demand Response Interface:
Activates Demand Response, affecting up four consecutive Echo Spaces,
starting with the interface Space rotary switch setting.
Example:
of Spaces 3, 4, 5, and 6. A value higher than 13 will result in control
of only Spaces 14, 15, and 16.
Note:
input.
Functionality:
a closed contact means the designated space is in active Demand
•
Response state
an open contact means Demand Response is inactive
•
Output Interface:
Relay outputs are controlled by Zones 1-4 respectively (when the Zone dial is
set to its default setting of 1). Changing the Zone dial will alter the starting
Zone. Reference the related note on
Contact and Demand Response Interfaces
Use EchoAccess to assign a different Preset for the contact.
Particularly when considering machine driven applications,
Example: Setting the Space switch to 3 results in control
Each Echo space can only have one assigned demand response
page 7
regarding zone ranges.
Page 5 of 8
ETC
Advertisement
Table of Contents
