ETC Sensor IQ Contact Input Control Option Card Installation Manual

ETC Installation Guide
Sensor IQ Contact Input Control Option Card
Overview
The Sensor IQ Contact Input Option Card (IQ-CI) provides the ability to directly control the circuits using a
momentary or maintained dry contact input. This document details the installation of this card in the
Sensor IQ Intelligent Breaker Panel.
Note:
Installation
The Contact Input Option Card can be installed on either interior wall of the low voltage
cavity.
1: There are four plastic standoffs included with the option card kit. Align the standoffs with the
mounting holes on the option card so the fins are located opposite the connectors.
2: Press gently until the plastic tabs pass through the mounting hole, locking into place.
3: Align the standoffs with the mounting holes on the interior of the low voltage cavity.
4: Press gently until the plastic tabs pass through the mounting hole, locking the option card into place.
Connect Wiring
The Contact Input Option Card provides four bus connections for termination of up to 24 individual dry
contact inputs. A pluggable screw connector is provided for each input and accepts 4–1 mm
Class 2 wire. Each connector is labeled to assist in relay referencing during termination.
1: Pull wire from the device supplying the contact closure into the Sensor IQ through the low voltage
trough. Reference the
information.
Corporate Headquarters Middleton, WI, USA +1 608 831 4116 London, UK +44 (0)20 8896 1000
Holzkirchen, DE +49 (80 24) 47 00-0 Rome, IT +39 (06) 32 111 683 Hong Kong +852 2799 1220 Paris, FR +33 1 4243 3535
Web
© 2020 Electronic Theatre Controls, Inc. Trademark and patent info:
Product information and specifications subject to change. ETC intends this document to be provided in its entirety.
7131M2170 Rev C Released 2020-06
It is best to install any panel option kits after conduit rough-in and load wiring
terminations are complete to reduce the likelihood of damage to the option card. For
additional information on panel installation, reference the
All ETC documentation is available for free download at
Install option card on
either interior wall.
Sensor IQ Installation Manual
etcconnect.com Support support.etcconnect.com
etcconnect.com
Contact Input
Option card
for cable routing and conduit access
Contact etcconnect.com/contactETC
etcconnect.com/ip
Sensor IQ Installation Manual.
.
Mounting
hole
Fins
Standoff
2
(12-18 AWG)