Personal Protective Equipment - Honeywell MILLER TurboLite EXTREME MFLEC-3/6FT User Instruction Manual

INSTRUCTIONS FOR USE

Personal Protective Equipment

EDGE
PERSONAL FALL LIMITERS
(OR SELF-RETRACTING
LIFELINES)
Thank you for your purchase of Honeywell
Miller fall protection equipment manufactured
by Honeywell Industrial Safety.
WARNING
trained.
It is crucial that the authorized person/user
of this equipment read and understand these
instructions. In addition, federal law requires
employers to ensure that all users are trained
in the proper installation, use, inspection, and
maintenance of fall protection equipment. Fall
protection training should be an integral part
of a comprehensive safety program.
Proper use of fall arrest systems can save
lives and reduce the potential of serious inju-
ries from a fall. The user must be aware that
forces experienced during the arrest of a fall
or prolonged suspension may cause bodily in-
jury. Consult a physician if there is any ques-
tion about the user's ability to use this product.
Pregnant women and minor children must not
use this product.
1.0 Purpose
Personal fall limiters
lifelines) are self-contained
devices designed to be used by personnel
in applications where fall protection in
combination with
mobility is needed.
TurboLite Edge Personal Fall Limiters are
specially-engineered retractable units with
unique features designed for leading edge
applications.
(or self-retracting
retractable
unrestricted worker
Honeywell Miller
2.0 General Fall Protection
Requirements
2.1 General Requirements
All warnings and instructions shall be provided
to authorized persons/users.
reference
ANSI or CSA standards.
-
-
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area
that could cause injuries or interfere with the
operation of the system.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
All equipment must be inspected before
each use according to the manufacturer's
instructions. Additionally, equipment must be
inspected by a competent person, other than
the user, on a regular basis, at least annually.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded in such a manner as to prevent
inadvertent further use.
Any equipment subject to a fall must be
removed from service.
The authorized
a rescue plan and the means at hand to
implement it when using this equipment.
Equipment must not be altered in any way.
Do not lubricate or attempt to repair this
device. Repairs must be performed only
by the manufacturer, or persons or entities
authorized in writing by the manufacturer.
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
the regulations
Please refer
person/user
governing
shall have
5