Table of Contents
Advertisement
Table 5. CCS Programming Steps
CCS Programming Steps
XLS-DVC
4
Create and program an MN
Active Tone.
5
Create and program a Fire
Active Tone (when Fire is the
highest priority).
6
Select FNA node in the All Call
list under General II tab
Subsidiary Equipment
The panels and network annunciators in this section may be
present on an MN network without being part of an ACU, LOC
or CCS. They do not have local control when an MN alarm is
active in the system. They are capable of initiating and
annunciating an MN alarm, but cannot perform acknowledge,
silence, or reset functions while an MN alarm is active in the
system.
Table 6. Subsidiary Equipment Programming Steps
Subsidiary Equipment Programming Steps
XLS3000*/XLS-NCA2
Field
1
Set the mass notification
priority
2
Set the DCC field.
3
Disable Local Control for
XLS3000 in network display
mode, and XLS-NCA2.
4
Map to MN nodes.(Include the
FNA node in the map).
5
Program with MN type IDs.
6
Program with MN Special
Function Zones.
XLS3000 may be in standard or network display mode.
XLS140-2/XLS120
1
Set the mass notification
priority
2
Set the DCC field.
3
Map to MN nodes.
4
Program with MN type IDs.
5
Program with MN Special
Function Zones.
HONEYWELL EMERGENCY NOTIFICATION MANAGER
Table 6. Subsidiary Equipment Programming Steps
Subsidiary Equipment Programming Steps
1
page 19
2
page 21
3
Fig. 16
4
5
6
**MN paging levels are not installed when the XLS-DVC
DVC-RPU
MN Paging Levels are not installed when the DVC-RPU acts
as a subsidiary device. Program the DVC-RPU label. Refer to
"DVC-RPU" on page 24.
MN ANNUNCIATOR PROGRAMMING
Program an
Refer to
annunciator (See page 25). Use XLS-DVC General Zones
Z501 - Z533 to annunciate LOC and ACU paging. Refer to
page 15
"XLS-DVC General Zones" on page 26.
page 13
Programming
page 14
DCC Participation
In a system with both MN and Fire support, DCC must always
page 17
be disabled for all XLS120s, XLS140-2s, XLS3000s, XLS-
NCA2s and EBI Workstation.
page 18
XLS3000/XLS-NCA2
Panel: In the Panel Settings Menu:
page 19
Set DCC Participation to NO to disable DCC Participation.
Fig. 9. Panel Settings Screen (2), XLS3000
page 15
page 13
page 17
page 18
page 19
13
XLS-DVC
Set the MN Mode**
Set the Associated Node
Number field.
Program input categories and
priorities.
Create and program an MN
Active Tone.
Create and program a Fire
Active Tone (when Fire is the
highest priority).
Select FNA node in the All Call
list under General II tab
acts as a subsidiary device.
annunciator as a
Fig. 15
Fig. 15
Fig. 21
page 19
page 21
Fig. 16
dedicated
MN
alarm
39-00008-1
Advertisement
Table of Contents
