Table of Contents
Advertisement
Unable to connect to the Internet.
Cause
Cable/DSL service is not available or has been interrupted due to
bad weather.
The CAT5 UTP cable is disconnected.
IP address is not configured properly.
Cookies are corrupted. (A "cookie" is a small piece of information
that a Web server can store temporarily with the Web browser.
This is useful for having the browser remember some specific
information that the Web server can later retrieve.)
Cannot automatically launch Internet programs.
Cause
You must log on to your ISP before some programs will start.
Solving software problems
Most software problems occur as a result of the following situations:
●
The application was not installed or configured correctly.
●
There is insufficient memory available to run the application.
There is a conflict between applications.
●
All the necessary device drivers might not have been installed.
●
If you have installed an operating system other than the factory-installed operating system, it might not be
●
supported on the system.
If you encounter software problems, see the applicable solutions listed in the following table.
Computer will not continue and the HP logo does not appear.
Cause
ROM issue - POST error has occurred.
54
Chapter 5 Troubleshooting without diagnostics
Solution
Try connecting to the Internet at a later time or contact your ISP. (If
the cable/DSL service is connected, the cable light on the front of
the cable/DSL modem will be on.)
Connect the CAT5 UTP cable between the cable modem and the
computers's RJ-45 connector. (If the connection is good, the PC light
on the front of the cable/DSL modem will be on.)
Contact your ISP for the correct IP address.
Windows 10:
1.
Type control panel in the taskbar search box, and then
select Control Panel from the list of applications.
2.
Click Internet Options.
3.
In the Browsing history section, click the Delete button.
4.
Select the Cookies and website data check box and click the
Delete button.
Solution
Log on to your ISP and launch the program.
Solution
Observe the beeps and lights on the front of the computer. See
POST error messages on page 70
See the Worldwide Limited Warranty for terms and conditions.
to determine possible causes.
Advertisement
Table of Contents
