Front Bezel - HP 268 Pro G1 MT Maintenance And Service Manual

Front bezel

The front bezel is secured to the access panel by tabs.
Before removing the front bezel, follow these steps:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the optical drive
4. Remove the drive cage
Remove the front bezel:
1. From the rear panel of the computer, disconnect the power button board cable (1) from the system board.
2. Disengage the front bezel tabs (2) from the top edge of the computer chassis.
3. Swing the top edge of the front bezel (3) down and away from the computer chassis.
4. Release the power button board cable through the opening (4) in the computer chassis.
5. Remove the front bezel (5).
To install the front bezel, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
(Optical drive on page 17).
(Drive cage on page 19).
17).
16).
Front bezel 21