Advertisement
SPARE PARTS, CONT.
Valve Front Section
Recommended lubricant:
All O-Rings & seals must be lubricated with Bimba HT-99, or equivalent, with
the exception of TSD400-71, which must remain dry.
ITEM
PART NUMBER
DESCRIPTION
16
TSD931-57
Luer Lock Adaptor
17
5320-000-001
Outlet Block For TS5322
17*
5320D-000-001
Outlet Block For TS5322D
18
TSD1400-014A
O-Ring, Buna
19
TSD931-75
Luer Lock Adaptor, Elbow
20
TSD1120-6
Retaining Ring, Medium
21
TSD1109-52
Flat Washer
22
TSD400-71
U-Cup Seal
23
5320-000-002
Body For TS5322
23*
5320D-000-002
Body For TS5322D
24
TD1103-349
Outlet Block Screw
TSD700-9
Oiler Cup, Not Shown
QTY
1
1
1
1
1
1
1
2
1
1
4
1
10
7.
MAINTENANCE AND CLEANING:
Tool required: O-ring removal tool (P/N TSD1597-7), snap ring pliers.
Normally, purging the valve with appropriate flushing material, or solvent after
use is sufficient for cleaning. However, some material may cause a build-up in the
valve chamber, in this case periodic and thorough cleaning will be required.
NOTE:
• Make sure the fluid pressure is released before valve is disassembled.
• To replace seals please order seal kit part number: 5322-SEALKIT.
• To repair valve please order valve kit part number: 5322VALVEKIT.
Cleaning and seal replacement for fluid housing: Refer to figure 5.0
7.1
1. Release fluid pressure.
2. Disconnect fluid line and remove fluid inlet fitting.
3. Disconnect valve air hose.
4. Hold the fluid housing (6) and rotate the air cylinder (18) counterclockwise.
When completely un-threaded, pull the two valve segments straight apart to
separate.
5. Inspect o-ring (17), replace if damaged.
6. Remove four socket head cap screws (12) from the outlet block (11).
7. Pull the outlet block (11) away from the fluid housing (6).
8. Inspect o-ring (10), replace if damaged.
9. Using snap ring pliers, remove retaining ring (8).
10. Remove stainless steel washer (9) from fluid housing (6).
11. Remove upper seal (14).
12. Clean the fluid housing (6), outlet block (11), spool assembly (5), upper and
lower seal (13) and (14).
NOTE: Avoid using sharp probes for cleaning. Any nicks or scratches on the
seal or the surfaces of the spool assembly may cause leakage
13. Inspect both upper (14) and lower seals (13), replace seals if damaged found.
14. Insert upper seal (14) into fluid housing (6) using the seal insertion tool 5322-
SIT. Make sure the o-ring side is facing down.
15. Insert stainless steel washer (9) and secure with retaining ring (8) using snap
ring pliers.
16. Insert lower seal (13) into outlet block (11). Make sure the o-ring side is facing
up.
7
Advertisement
