Silvercrest SHBS 500 B1 Operating Instructions Manual page 49

__GRA93480_B2.book Seite 47 Montag, 9. September 2013 10:28 22
• Only use the included original power adaptor for mains
operation.
DANGER for children
• Packing materials are not children's toys. Children should not be allowed
to play with the plastic bags: There is a risk of suffocation.
• Keep the device out of the reach of children.
DANGER! Risk of electric shock due to moisture
• Do not use this device in the vicinity of bathtubs, showers, washbasins or
other vessels containing water.
• Protect the device from moisture, water drops and water spray.
• Never touch the device with wet hands.
• The device, the cable and the power unit must not fall into water or other
liquids and must not be rinsed under running water.
• If the device has fallen into water, pull out the power unit immediately, and
only then remove the device from the water. Do not use the device again,
but have this checked by a specialist.
• Should liquid enter the device, have it checked before starting the device
up again.
• If the device is used in a bathroom, the power unit must be pulled out after
use, as the proximity of water represents a hazard, even when the device is
switched off.
• Installation of a residual current device (FI/RCD) with a rated residual oper-
ating current of no more than 30 mA is recommended to provide addition-
al protection. Ask your electrician for advice. The installation should only
be carried out by a qualified electrician.
DANGER! Risk of electric shock
• Never put the device into operation if there are visible damages to the de-
vice, the power unit or the cable or if the device has been dropped before.
• Connect the cable to the device before plugging the power unit into a wall
socket.
• Only connect the power unit to a properly installed, easily accessible wall
socket, the voltage of which corresponds to the specifications on the rating
plate. The wall socket must continue to be easily accessible after the device
is plugged in.
• Ensure that the cable cannot be damaged by sharp edges or hot surfaces.
• Ensure that the cable is not trapped or crushed.
GB 47