Table of Contents
Advertisement
CHOOSING A LOCATION
Choosing a Location for the Controller, continued.
A room temperature sensor is inside the controller, so the installation location is critical to proper system operation. Install the controller in a
location away from direct sunlight, high humidity, and direct flow or hot or cold air. Install the controller on a flat, clean wall surface approxi-
mately four to five (4 to 5) feet above the floor in an area with good circulation and average temperature.
Do's
• If replacing an existing controller, label wires before removing.
• Ensure the wall surface is flat and clean.
• Ensure the controller has sufficient, natural air circulation.
• Ensure the external thermal sensor wiring is away from electrical
sources.
• Install the controller four to five (4 to 5) feet (1.2 to 1.5m) above the
floor.
Do Not's
Do not install the controller:
• In drafts or dead spots behind doors and corners.
• In areas subjected to hot or cold air from ducts / air discharge grilles
• Near radiant heat from sun or appliances
• Near or with a direct heat source.
• In areas exposed to direct sunlight.
• Near concealed pipes or chimneys.
• Uncontrolled areas such as on an outside wall.
Failure to comply with these recommendations will result in damage to the unit and void the manufacturer's warranty.
10
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
Figure 1: Controller Location.
NO
NO
YES
4 to 5 feet
NO
above the floor
Advertisement
Table of Contents
