Table of Contents
Advertisement
Terminal Commands (Cont.)
Command
MEM
MSG ON|OFF
PING [ADDRESS]
PWD
REBOOT
RELEASE DHCP
SECURITY SETUP
SET DATE
NXB-KNX NetLinx KNX Interface
Description
Displays the largest free block of the NXB-KNX's memory.
Example:
>MEM
The largest free block of memory is 11442776 bytes.
Enables/Disables extended diagnostic messages.
• MSG On sets the terminal program to display all messages
generated by the NXB-KNX.
• MSG OFF disables the display.
Example:
> MSG ON
Extended diagnostic information messages turned on.
> MSG OFF
Extended diagnostic information messages turned off.
Pings an address (IP or URL), to test network connectivity to and con-
firms the presence of another networked device. The syntax is just like
the PING application in Windows or Linux.
Example:
>ping 192.168.29.209
192.168.29.209 is alive.
Displays the name of the current directory.
Example:
pwd
The current directory is doc:
Reboots the NXB-KNX.
Example:
>REBOOT
Rebooting...
Releases the current DHCP lease for the NXB-KNX.
Note: The NXB-KNX must be rebooted to acquire a new DHCP lease.
Example:
>RELEASE DHCP
Modify system security settings.
Prompts you to enter the new date for the NXB-KNX.
Example:
>SET DATE
Enter Date: (mm/dd//yyyy) ->
Note: Due to the absence of a battery-backed real-time clock, setting
the current date is only valid for the life of the current run. When the
unit is rebooted, the date will be lost.
Programming - Telnet Commands
17
Advertisement
Table of Contents
