Table of Contents
Advertisement
Terminal Commands (Cont.)
Command
SET HTTPS PORT
SET IP
SET LOG COUNT
SET SSH PORT
NXB-KNX NetLinx KNX Interface
Description
Sets the NXB-KNX's IP port listened to for HTTPS connections.
Note: The NXB-KNX must be rebooted to enable new settings.
Example:
>SET HTTPS PORT
Current HTTPS port number = 443
Enter new HTTPS port number (Usually 443) (0=disable HTTPS):
Once you enter a value and press the ENTER key, you get the follow-
ing message:
Setting HTTPS port number to
New HTTPS port number set, reboot the NXB-KNX for the change
to take affect.
Sets the IP configuration.
Enter a Host Name, Type (DHCP or Fixed), IP Address, Subnet Mask,
and Gateway IP Address.
Note: For NetLinx Central Controllers, the "Host Name" can only
consist of alphanumeric characters.
• Enter Y (yes) to approve/store the information into the NXB-KNX.
• Enter N (no) to cancel the operation.
Note: The NXB-KNX must be rebooted to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter to keep current settings ---
Enter Host Name:
MLK_INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and then Enter:
DHCP
Enter Gateway IP:
192.168.21.2
You have entered: Host Name
Type
Gateway IP
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable new settings.
Sets the number of entries allowed in the message log.
Note: The NXB-KNX must be rebooted to enable new settings.
Example:
>SET LOG COUNT
Current log count = 1000
Enter new log count (between 50-10000):
Once you enter a value and press the ENTER key, you get the follow-
ing message:
Setting log count to
New log count set, reboot the NXB-KNX for the
change to take affect.
Sets the NXB-KNX's IP port listened to for SSH connections.
Note: The NXB-KNX must be rebooted to enable new settings.
Example:
>SET SSH PORT
Current SSH port number = 22
Enter new SSH port number (Usually 22) (0=disable SSH):
Once you enter a value and press the ENTER key, you get the follow-
ing message:
Setting SSH port number to 22
New SSH port number set, reboot the NXB-KNX for
the change to take affect.
Programming - Telnet Commands
MLK_INSTRUCTOR
DHCP
192.168.21.2
19
Advertisement
Table of Contents
