Installation - ETC Unison Echo Forward-Phase Dimmer-Gen 2 Installation Manual

Table of Contents

Advertisement

ETC Installation Guide
Forward-Phase Dimmer–Gen 2

Installation

Installation should follow all local codes and standard electrical practices.
Ensure that the junction box is clean and free of obstructions and that all
wiring is installed correctly.
WARNING:
and should only be installed by a qualified installer or electrician. Follow
all local codes for installation. Before terminating the AC power wiring
verify that the main breaker is in the off position and follow the proper
lockout/tag out procedures per NFPA Standard 70E.
AVERTISSEMENT:
utilise une haute tension et ne doit être installé que par un installateur
qualifié ou un électricien. Suivez tous les codes locaux pour l'installation.
Avant de raccorder le câblage du courant alternatif, vérifiez que le
disjoncteur principal est en position d'arrêt et suivez les procédures de
Consignation/Déconsignation prescrites par la norme NFPA 70E.
WARNING:
box or wireway.
AVERTISSEMENT:
installé sur une boîte de raccordement électrique ou un chemin de câbles.
1.
2.
3.
Note:
Forward-Phase Dimmer–Gen 2
Risk of electric shock! This device utilizes high voltage
Risque de décharge électrique! Cette appareil
For indoor use only! Must install to an electrical junction
Uniquement pour usage d'intérieur! Doit être
Locate the circuit breaker panel and turn off the power to the lighting
circuit.
To gain access to the line voltage wiring, remove the cover plate and
other hardware from the junction box at the load.
Mount the Forward-Phase Dimmer–Gen 2 to the exterior of the
junction box or panel using the 1/2 in threaded nipple. Use the
provided 1/2 in conduit locknut to secure the Forward-Phase Dimmer–
Gen 2 to the junction box or panel.
Follow all local code requirements for terminating wire.
Notice that the harness wires on the controller are pre-stripped
for your installation convenience.
Use appropriately sized wire nuts (not provided) to terminate
power wires, and use included WAGO
terminate EchoConnect wires.
®
connectors to
Page 5 of 12
ETC

Advertisement

Table of Contents
loading

Table of Contents