Power Up And Test; Power-Up Behavior - ETC Unison Echo Forward-Phase Dimmer-Gen 2 Installation Manual

ETC Installation Guide
Forward-Phase Dimmer–Gen 2
Assign Zones and Spaces
You can assign zones and spaces using
the two rotary switches on the side panel
of the controller.
By default, these switches are set to
Zone 1, Space 1. Control inputs from the
connected stations, sensors, and other
controls are shared by all devices within a
space.
1.
2.

Power Up and Test

1.
2.
3.

Power-Up Behavior

In the event of a power loss to the Forward-Phase Dimmer–Gen 2, the
controller will return to its last output level when power is restored.
Forward-Phase Dimmer–Gen 2
Set the Zone rotary switch to the
desired Zone address for this
controller.
Set the Space rotary switch to
the desired Space for this
controller.
Restore power to the circuit. The
Forward-Phase Dimmer–Gen 2
will power up and turn on all connected loads to full output.
Test the circuit by activating the associated Echo station preset or by
changing the zone intensity control.
Test the controller response. Use station controls to alter preset or
zone status, and ensure that the Forward-Phase Dimmer–Gen 2
responds.
Rotary
switches
Page 8 of 12 ETC