Update Firmware - ETC Unison Echo Forward-Phase Dimmer-Gen 2 Installation Manual

ETC Installation Guide
Forward-Phase Dimmer–Gen 2

Update Firmware

If updated firmware is required, you can update the firmware on the Forward-
Phase Dimmer–Gen 2 by using ETC UpdaterAtor software and a microSD
card. You can download UpdaterAtor from the ETC website at
etcconnect.com
Note:
the Forward-Phase Dimmer–Gen 2.
1.
2.
3.
4.
5.
Forward-Phase Dimmer–Gen 2
, or you can access UpdaterAtor from Concert software.
Plan to update firmware when troubleshooting any issues with
Get the firmware update file using UpdaterAtor.
Save the firmware update file to the root directory of a microSD card.
Ensure that power is supplied to the controller.
Insert the microSD card in the SD slot on the side of the Forward-
Phase Dimmer–Gen 2 enclosure.
The Dim Mode LED will illuminate amber in a triple-blink
•
pattern while the firmware is updating, and then will return to its
previous state when the update is complete.
If the LED illuminates red in a double-blink pattern, an error has
•
occurred. Ensure that the firmware file has not been renamed
and is located at the root directory on the microSD card, and then
attempt the firmware update again. If the LED continues the
double-blink pattern, contact ETC Technical Services using the
information at the bottom of page 1.
When the LED returns to its previous state, remove the microSD card.
Page 11 of 12
microSD
card slot
ETC