Revision Mode - Honeywell Esser 2 Series Operation And Installation Instruction

Extinguishing control computer
Table of Contents

Advertisement

Available languages

Available languages

Extinguishing Control Computer 8010 - Series 2

12.8 Revision mode

The Extinguishing Control Computer 8010 can be switched to the revision mode via the function keys on the
operating panel. The keyboard must be released by the key switch.
The revision mode display has priority over the test mode. If an alarm zone is for example in test
mode and the revision mode is switched on in addition, the state of the >Test mode< LED changes
from ON to flashing. In the deactivated revision mode the >Test mode< LED lits continuously.
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
locked
Extra releasing 1
Outputs
Alarm
Fig. 13: Example of switching mode – switching on revision mode
Selecting the revision mode activates all outputs programmed with the status function >Revision<. All outputs of
the Extinguishing Control Computer remain activated until the revision mode is deactivated.
The following key sequence is used to deactivate the revision mode:
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Un-
locked
Extra releasing 1
Outputs
Alarm
Fig. 14: Operating example – switching off the revision mode
Zones and outputs which are disconnected or out of order will not send an alarm in the event of a fire!
74
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Test
Switching off
operation
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Test
Switching off
operation
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
On
Test operation
Extra releasing 1
Outputs
Alarm
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Off
Test operation
Extra releasing 1
Outputs
Alarm
FB 798352 / 11.07

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Esser 8010Lmst 8010Esser lmst 8010788010788011788012 ... Show all

Table of Contents