Status Display Of The Outputs - Honeywell Esser 2 Series Operation And Installation Instruction

Technical zone no.10 to no.13 (yellow LED)
Off
Lights up yellow
Flashes yellow
Twinkle yellow

12.1.2 Status display of the outputs

Status display of the
outputs is switched on
Fig. 3: Outputs displays
Outputs no.1 to no.13 (yellow LED)
Off
Flashes
On
Twinkle
Disconnected or zones in trouble will not signal an alarm in case of an event!
FB 798352 / 11.07
Normal operation, technical zone is alarm-ready
1) Triggers the technical zone 10 to 13
2) Switch-off. The technical zone was switched off. The yellow LED >Switch off<
also lights up
Trouble
Input check- the zone number was entered via the control panel keypad
In operation
Extinguishing system
enabled
Extinguishing system
activated
Emergency release
Switching off
Test operation
Extra releasing 1
Outputs
Alarm
Normal operation, the output is in the resting state
Output failure
Output deactivated
Input check -the output number was entered via the control panel keypad
Extinguishing Control Computer 8010 - Series 2
Detector zone
1 2 3
9 10 11 12 13
Fire/Switch off/Trouble
4 5 6 7 8
65