Functioning Control - IACER I-TECH MAG2000 PLUS User Manual

Maintance
If used as prescribed on this manual, the equipment does not require a
specific routine maintenance.
In case of malfunctioning problems, please follow these simple instructions:
1. check that the power outlet to which the appliance is connected
works regularly by connecting another working device;
2. check the connection with the power supply and the integrity of all
the connection cables;
3. check the connection with the applicator (or the applicators);
4. make sure that all the operations have been properly done;
5. verify every two years the device and its full functionality (by
contacting the manufacturer).
If you are experiencing any problems or if you need any further information,
please contact the manufacturer immediately.

FUNCTIONING CONTROL

MAG2000 PLUS is equipped with a magnet (small ring or metal or
metal/plastic disc) in order to control the device functioning.
Control procedures:
1. switch on the appliance according to all the safety requirements
defined in this manual;
2. activate any therapy in accordance to user manual instructions;
3. get the supplied magnet and place it close to the applicator;
4. check the vibration of the magnet (it will be proportional to the
frequency of the selected therapy).
Please contact the manufacturer in case of magnet vibration absence.
CLEANLINESS
It is suggested to remove any trace of dust after each use of the device (and
its accessories) by using a soft dry cloth.
We recommend disconnecting the applicator from the device before
cleaning the elastic therapeutic belt with 3 solenoids or the circular cases
of professional solenoids couple.
Extract the cable with 3 solenoids by removing the 2 silver studs through a
screwdriver or open the circular cases through lateral zip.
Clean the tissue by using water and mild soap and wait for the complete
drying before reconnecting the applicators.
IACER Srl
Care of the device
25 MNPG53-07