Advertisement
5 IDS NXT rio
Housing/board-level
Dimensions height x width x length
Mechanical specifications
IP code
Ambient conditions
Lens mount
Mounting holes bottom/top/side/front
Thread diameter
Status LED
Interface connector
Power supply
I/O connector
Electrical specifications
5.1 Ambient conditions
The temperature values given below refer to the outer device temperature of the camera housing. The
temperature inside of the camera housing is generally higher than the outer temperature and may be up to
70 °C (158 °F).
Device temperature during operation
Device temperature during storage
Humidity
Non-condensing means that the relative air humidity must be below 100 %. Otherwise, moisture will form on
the camera surface. If, for example, air has a relative humidity of 40 % at 35 °C (95 °F), the relative humidity
will increase to over 100 % if the air cools down to 19.5 °C (67 °F); condensation begins to form.
CAUTION! As the camera housing may get hot depending on the operating conditions there
may be risk of burns. Provide sufficient heat dissipation so that the housing temperature does
not exceed 55 °C (131 °F).
Notes on ambient conditions
·
Avoid high air humidity levels and rapid temperature changes when using IDS cameras.
·
Temperatures below +4 °C (39 °F) combined with excessive relative air humidity levels can cause icing.
Provide sufficient heat dissipation so that the specified device temperature is not exceeded during operation.
In general, the following recommendations apply:
·
For a passive heat dissipation, mount the camera on a thermally-conductive surface like a metal plate or a
heat sink.
·
If necessary, provide an active cooling for example by means of a fan.
With increasing device temperatures, the image quality could be reduced due to thermal noise. It is
recommended to mount the camera to a heat-dissipating unit even if the camera is operated below the
maximum specified temperature.
2021-04-13
+/-
34 x 44 x 73 mm
Mechanical specifications
IP 30
·
Schutz gegen das Eindringen kleiner Fremdkörper
·
Kein Wasserschutz
Ambient conditions
C-mount, see Optical specifications
4/0/0/0
M3
Status LED
GigE RJ45, screwable
Input I/O connector (M12): 12-24 V DC +20 %, max. 1 A
Input GigE connector (RJ45): PoE 41-57 V DC, max. 350 mA
12-pin M12
connector, screwable
Electrical specifications
0 °C ... 55 °C
32 °F ... 131 °F
-20 °C ... 60 °C
-4 °F ... 140 °F
20 % ... 80 %, relative, non-condensing
IDS NXT: Setup IDS NXT rio
9
Advertisement
