rockymounts TieRod 10120 Installation Manual

Advertisement

Quick Links

Guidelines/Restrictions:

- This carrier is intended for elliptical shaped factory crossbars.
- Bicycles must be equipped with a quick release front wheel.
- Minimum crossbar spread is 16 inches, maximum 40 inches.
- Do not exceed the load capacity of your vehicle's roof rack, 2 bike maximum for factory bars.
- Bicycle weight limit is 35lbs with this carrier.
- Use of forks equipped with carbon fiber dropouts or forks without safety tabs will void the warranty.
Step 1:
Slide two Carriage Bolts into the slot on the bottom of the Wheel Tray
four carriage bolts in the hardware kit, the shorter ones fit 98% of cars, use these first, and if
they are too short, use the longer ones.
Step 2:
Remove the cover plate from the head by pulling up on the tab, and unhook the T-ends of the
straps from the head. Place the rack onto your crossbar with the Carriage Bolts on either side of
the rear bar and the T-end straps under the front crossbar (Figure#2). Open up and check the
hatchback does not hit the end of the Wheel Tray. If it does, you can reverse the carrier and
face backwards.
Figure #1
Step 3:
Hook both T-ends back into their fittings (if they do not reach, loosen the bolt) and tighten the
bolt with the enclosed allen wrench
Step 4:
Line up the two Carriage Bolts and pass them through the holes in the black Steel Bracket.
Underneath, thread the 2 plastic WingNuts onto the bolts and tighten
TieRod Installation Manual
(Figure
#3).
www.
www.rockymounts.com
www.
www.
rockymounts.com
rockymounts.com
rockymounts.com
(Figure
#1). There are
Figure #2
(Figure #4).

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TieRod 10120 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for rockymounts TieRod 10120

  • Page 1 TieRod Installation Manual Guidelines/Restrictions: - This carrier is intended for elliptical shaped factory crossbars. - Bicycles must be equipped with a quick release front wheel. - Minimum crossbar spread is 16 inches, maximum 40 inches.
  • Page 2 - Do not use bicycle covers, bicycle bras, or bikes equipped with disc wheels. - Do not take the vehicle off road, if you must, drive cautiously. - Locks are only deterrents to thieves, RockyMounts cannot be held liable for stolen bicycles. - Remove rack before entering a car wash.
  • Page 3 Rock the bicycle side to side to ensure proper mounting. The fork should be properly seated and not move. If unsure, please consult your dealer or RockyMounts. Failure to comply could result in the bicycle detaching with subsequent damage to the bicycle, vehicle, or other motorist.

Table of Contents