Warnings And Notes - Harvia Xenio WiFi User Manual

Read the warnings and manual carefully before using the product!
EN
The control panel is meant for controlling the sauna heater and the functions intended for the
control unit. It is not to be used for any other purpose! This device is allowed to use by 8 years old
or older children and persons with reduced physical, sensory or mental capabilities, or persons with lack
of experience and knowledge, if they are supervised or they have been instructed to use the device safely
and if they are aware of the dangers involved. Children should not play with the device. Children should not
clean or do operations to the device without supervision.
Installation and maintenance
The electrical device may only be connected to the electrical network in accordance with the
current regulations by an authorised, professional electrician. After completing the
installation, the person in charge of the installation should give these instructions to the
owner of the sauna or to the person in charge of its operation.
All maintenance that requires special skills must be performed by a trained professional.
Always disconnect the device from the electricity network before carrying out any
maintenance work!
• Check the device for visible damage before installing and using the device. Do not use a damaged device.
• It is absolutely necessary to install the device according to values stated in the instructions of installation
and use. Neglecting them causes a risk of fire.
• If suitable accessories are installed in the device, follow the accessory-specific operating and installation
instructions!
• If the supply cord is damaged, it must be replaced by the manufacturers' service person or a similarly
qualified person in order to avoid a hazard.
• Clean the product by using a lightly moistened cloth. Use only mild cleaning agents, never solvents or
corrosive chemicals.
• This product should not be disposed of with general household waste. When recycling your product,
take it to your local collection facility or contact the place of purchase.
Instructions for use and bathing
Always check that there are no objects on the heater or near the heater before switching it on.
• Always check that the heater has switched off and stopped heating after the on-time period has elapsed.
• In public saunas, where the heater is used without a timer or continuously for longer than the timer of
the heater or the control unit allows with the factory settings, the device must be constantly supervised.
• The sauna room and surroundings of the heater must always be checked before the heater is switched
on again or it is switched on with the remote control system.
• The sauna room and surroundings of the heater must always be checked before the device is brought
into standby mode required by remote control or pre-timed operation.
• According to the product standard IEC/EN 60335 -2-53 regulating electrical sauna heaters, the control
unit can be used to remotely control the heater once the heater or sauna room door is equipped with a
secure switch (safety or door switch).
34

WARNINGS AND NOTES