Kohler KD83V16 Service And Repair Manual page 16

Contents
5 Appendix
5.1
5.2
5.3
5.4
5.5
16
4.1.1 Special tools
4.1.2 Turning device
Technical design documents
Cleaning agents, thread-locking adhesives and greases
5.2.1 Cleaning agents and thread-locking adhesives
5.2.2 Greases
Standard tightening torques
5.3.1 Screws pre-tightening, reuse and marking
5.3.2 Standard torques for hexagonal / socket / flange screws
5.3.3 Standard torques for internal drive pipe plug with conical thread
5.3.4 Standard torques for locking screws and banjo bolts
5.3.5 Standard torques for metric flange joints
5.3.6 Standard torques for metric thread unions L series (up to 500 bar/7252
Psi)
5.3.7 Standard torques for metric thread unions S series (up to 800 bar/
11603 Psi)
5.3.8 Standard torques for imperial thread unions L series (up to 500 bar/
7252 Psi)
5.3.9 Standard torques for imperial thread unions S series (up to 800 bar/
11603 Psi)
5.3.10 Standard torques for metric thread unions L series (up to 500 bar/7252
Psi) for aluminum
5.3.11 Standard torques for cutting ring flange joints
5.3.12 Standard torques for triple lock flange joints
5.3.13 Standard torques for VSTI screw plugs
Abbreviations - Acronyms
Unit conversion tables
5.5.1 Length conversion factors
5.5.2 Mass conversion factors
5.5.3 Pressure conversion factors
5.5.4 Volume conversion factors
5.5.5 Power conversion factors
5.5.6 Moment of inertia and torque conversion factors
5.5.7 Fuel consumption conversion factors
5.5.8 Flow conversion factors
© 2019 by Kohler Co. All rights reserved.
Service and Repair Manual
KD83V16 33525088901_1_1 EN_US
193
196
199
199
200
200
200
201
201
203
204
205
206
206
207
208
209
209
210
211
212
215
217
217
217
217
217
218
218
218
218
2019-02