Assembly - Billy Goat FORCE 602V Owner's Manual

FORCE
TM

ASSEMBLY

NOTE: All items referenced in ( ) can be found in the Illustrated Parts Drawing and Parts List found at the back of the
manual.
1. First, attach the front wheel. The hardware
to secure the wheel (spacer, bolt, and nut)
are included with your unit. Gently lower
TM
your Billy Goat Force
back to access the front wheel bracket.
Insert the spacer into the front wheel. Then,
place the wheel into the front wheel
bracket. Line up the wheel axle holes with
the holes in the bracket. Insert the bolt into
the bracket and front wheel, and then
secure the wheel with the nut provided.
Use 9/16" wrenches to tighten the
hardware and further secure the front
wheel assembly. See Figure 1. With the
front wheel attached, gently lift your Billy
TM
Goat Force Blower into operating
position. Chock the front wheel to keep the
unit from moving while you assemble the
handles.
2. Second, assemble the handles. Locate the
upper handle assembly hardware, two bolts
and two knobs. Line up the upper handle to
the lower handles. Secure the upper
handle to the lower handle with the bolt
and knob. Tighten by hand. Note that the
knob should be installed inside the handle
assembly. See Figure 2. Secure the
opposite side of the handle assembly with
the remaining bolt and knob.
3. Finally, connect the Aim-N-Shoot
One end of the Aim-N-Shoot
connected to the air director cone, but you
will need to connect the ball end of the
cable to the Aim-N-Shoot
the upper handle. First, locate the rolled up
cable beneath the unit. Then unroll the
cable, thread the cable to the outside of the
machine and up to the handle. Push down
on the air director cone to release extra
length on the ball end of the cable. See
Figure 3. With the extra length released,
attach the Aim-N-Shoot
holder on the Aim-N-Shoot
See Figure 4. Finally, secure your Aim-N-
TM
Shoot cable to the unit with the zip ties
provided.
Part No 441502
602V/X BLOWER Owner's Manual
Blower onto its
TM
cable.
TM
cable is
TM
control lever on
TM
cable to its
TM
control lever.
Fig. 1
Fig. 2
5 441502_A_HI