Extending The Drift Breakers; Figure 5 - Toro Power TRX 1428 OHXE Operator's Manual

1. Nuts on the speed cable
C. Pull the cable downward.
D. Tighten the 2 nuts.
4. Release the traction lever.
4

Extending the Drift Breakers

No Parts Required
Procedure
Extend the drift breakers as needed.

Figure 5

5. Push the speed selector slightly out of the
neutral position; refer to
Selector (page
6. Squeeze the left (traction) lever to the handgrip
(Figure 4).
The machine should move forward. If the
machine does not move or moves rearward,
complete the following:
A. Release the traction lever and shut off the
engine.
B. Loosen the 2 nuts on the speed cable
resting on the speed-selector-lever bracket,
located under the control panel
C. Push the cable upward.
D. Tighten the 2 nuts.
g326129
7. If you made any adjustments, repeat this
procedure until no adjustments are required.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 18)
to an Authorized Service Dealer for service.
6
Operating the Speed
12).
(Figure
Checking and Adjusting
or take the machine
5).
g258084