Toro Power TRX 1428 OHXE Operator's Manual page 27

Problem
The engine runs, but the machine
discharges snow poorly or not at all.
The discharge chute either does not lock
into place or does not move.
The machine does not properly clear the
snow off the surface.
Possible Cause
1. The throttle is not in the F
when throwing snow.
2. The machine is moving too fast to clear
the snow.
3. You are trying to remove too much
snow per swath.
4. You are trying to remove extremely
heavy or wet snow.
5. The discharge chute is plugged.
6. The auger/impeller drive belt is loose
or is off the pulley.
7. The auger/impeller drive belt is worn
or broken.
1. The discharge-chute latch is not
properly adjusted.
1. The skids and/or scraper are not
properly adjusted.
25
position 1. Move the throttle to the F
AST
2. Shift the machine into a lower gear.
3. Reduce the amount of snow removed
per swath.
4. Do not overload the machine with
extremely heavy or wet snow.
5. Unclog the discharge chute.
6. Install and/or adjust the auger/impeller
drive belt; refer to
for servicing information or take the
machine to an Authorized Service
Dealer.
7. Replace the auger/impeller drive belt;
refer to
information or take the machine to an
Authorized Service Dealer.
1. Adjust the discharge-chute latch.
1. Adjust the skids and/or the scraper.
Corrective Action
position.
AST
www.Toro.com
www.Toro.com for servicing