Checking And Adjusting The Traction Cable - Toro Power TRX 1428 OHXE Operator's Manual

Figure 27
1. Hex head adjustment bolts
C. Ensure that the deflection of the track is
approximately 9.5 mm (3/8 inch).
D. Tighten the nuts on the rear roller yoke.
E. Repeat for the other track.
Checking and Adjusting the
Traction Cable
Service Interval: After the first 2 hours—Inspect
the traction cable and adjust it if
necessary.
Yearly—Inspect the traction cable and adjust or
replace it if necessary.
If the machine does not drive in the forward or reverse
speeds or it drives when you release the traction lever,
adjust the traction cable.
With the traction level disengaged, ensure that the
there is no slack in the traction cable
Figure 28
If there is slack in the traction cable, the left (traction)
cable is not properly adjusted.
To adjust the traction cable, do the following:
1.
2.
3.
g325789
1. Turnbuckle
(Figure 28).
g325790
18
Loosen the jam nut (Figure
Loosen or tighten the turnbuckle until the cable
is taught.
Tighten the jam nut.
Figure 29
29).
g325791
2. Jam nut