Introduction - Toro Power TRX 1428 OHXE Operator's Manual

Introduction

This machine is intended to be used by residential
homeowners and professional, hired operators. It
is designed primarily for removing snow from paved
surfaces, such as driveways and sidewalks, and
other surfaces for traffic on residential or commercial
properties. It is not designed for removing materials
other than snow. Using this product for purposes
other than its intended use could prove dangerous to
you and bystanders.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
Visit www.Toro.com for product safety and operation
training materials, accessory information, help finding
a dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information.
1. Model and serial number location
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
CV
Power TRX ™
OHXE Snowthrower
Model No. 38870—Serial No. 400000000 and Up
Model No. 38875—Serial No. 400000000 and Up
Figure 1
Figure 1
Register at www.Toro.com.
Commercial 1428 OHXE and 1432
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure 2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
This product complies with all relevant European
directives; for details, please see the separate product
specific Declaration of Conformity (DOC) sheet.
Important:
1500 m (5,000 ft) for a continuous period, ensure
that the High Altitude Kit has been installed
so that the engine meets CARB/EPA emission
regulations. The High Altitude Kit increases
engine performance while preventing spark-plug
fouling, hard starting, and increased emissions.
Once you have installed the kit, attach the
high-altitude label next to the serial decal on the
machine. Contact any Authorized Toro Service
Dealer to obtain the proper High Altitude Kit and
high-altitude label for your machine. To locate
a dealer convenient to you, access our website
at www.Toro.com or contact our Toro Customer
Care Department at the number(s) listed in your
g323171 Emission Control Warranty Statement. Remove
the kit from the engine and restore the engine to
its original factory configuration when running the
engine under 1500 m (5,000 ft). Do not operate an
engine that has been converted for high-altitude
Form No. 3439-453 Rev A
Operator's Manual
Figure 2
Safety-alert symbol
If you are using this machine above
All Rights Reserved *3439-453* A
Original Instructions (EN)
Printed in the USA
g000502