Starting The Engine - Toro Power TRX 1428 OHXE Operator's Manual

•
Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
•
Exercise extreme caution when operating the
machine on a slope.
•
Do not operate the machine without good visibility
or light.
•
Look behind and use care when backing up the
machine.
•
When not actively clearing snow, disengage power
to the auger.
•
Exercise extreme caution when operating the
machine on or crossing gravel drives, walks, or
roads. Stay alert for hidden hazards or traffic.
•
Never attempt to make any adjustments while
the engine is running, except as directed in the
instructions.
•
After striking a foreign object, shut off the engine,
remove the key, and inspect the machine for

Starting the Engine

Using Electric Start
Note:
To use the electric starter (electric-start models only), connect a power cord to the plug-in first and
then to a power outlet. Use a certified 1.3 mm² extension cord recommended for outdoor use that is not
longer than 15 m (50 ft).
WARNING
The electrical cord can become damaged, causing a shock or fire.
Thoroughly inspect the electrical cord before using the machine. If the cord is damaged, do
not use it. Replace or repair the damaged cord immediately. Contact an Authorized Service
Dealer for assistance.
CAUTION
If you leave the machine plugged into a power outlet, someone can inadvertently start the
machine and injure people or damage property.
Unplug the power cord whenever you are not starting the machine.
damage. Repair any damage before starting the
machine.
•
If the machine starts to vibrate abnormally, shut off
the engine and check immediately for the cause.
•
Do not run the engine indoors; exhaust fumes are
dangerous.
•
Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
•
Disengage all clutches and shift into neutral before
starting the engine.
•
Shut off the engine whenever you leave the
operating position, before clearing or unclogging
the collector, impeller, or discharge chute, and
when making any repairs, adjustments, or
inspections.
•
Never operate the machine at high transport
speeds on slippery surfaces.
9