Download Print this page

olympia electronics KLIN-20/ST Quick Start Manual

Self testing maintained/non-maintained emergency luminaire

Advertisement

Quick Links

NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X: Self contained
1: Maintained (*)
A: Including test device
E: With non-replacable lamp(s) and/or battery
F: Automatic test gear complying with IEC 61347-2-7 denoted EL-T
60: 1 hour duration
180: 3 hours duration
480: 8 hours duration
X 1
A E F
1
8 0
(*) Maintained operation: The luminary lights its illumination source, when it is
powered by the mains power supply or not.
Non Maintained operation: The luminary lights its illumination source, only in mains
power supply's failure.
ATTENTION!!!
The light source of this luminary is not replaceable when the light source
reaches its end of life the whole luminary shall be replaced.
Technical Characteristics
MAINS VOLTAGE
220-240V AC / 50-60Hz
MAXIMUM POWER CONSUMPTION
BATTERY (Ni-Mh)
BATTERY PROTECTION
Overcharging and deep discharging protection
INDICATIONS
Charge LED, Lamp fault LED, Battery fault LED / Test button
RECHARGING TIME
MINIMUM EMERGENCY DURATION
1 h / 3 h / 8 h manually selected (default 3h)
LIGHT SOURCE INTENSITY (230V)
LIGHT SOURCE INTENSITY (EMERGENCY)
1 h : 250lm / 3 h : 110lm / 8 h : 15lm
DEGREES OF COVER PROTECTION
EN 60598-1, EN 60598-2-22, EN 55015
PRODUCED IN ACCORDANCE WITH
EN 61547, EN 61000-3-2, EN 61000-3-3
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS (LXWXH)
TYPICAL WEIGHT
GUARANTEE
3 years (1 year for the battery)
LED Characteristics
MANUFACTURER
Olympia Electronics S.A.
MODEL NUMBER
VOLTAGE RANGE
NOMINAL POWER
CONNECTIONS
TEMPERATURE (tc)
4
Olympia Electronics guarantees the quality, condition and operation of the goods. The
period of warranty is specified in the official catalogue of Olympia Electronics and also in
the technical leaflet, which accompanies each product. This warranty ceases to exist if
the buyer does not follow the technical instructions included in official documents given
by Olympia Electronics or if the buyer modifies the goods provided or has any repairs or
re-setting done by a third party, unless Olympia Electronics has fully agreed to them in
writing. Products that have been damaged can be returned to the premises of our
company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to
or not charge the buyer depending on the reason of defection. Olympia Electronics
reserves the right to charge or not the buyer the transportation cost.
KLIN-20/ST
3.9W/4.4VA
3.6V/1.5VA
24 hours
80lm
IP44
o
5 to 40 C
up to 95%
PC
260x35x60mm
405gr.
KLIN-20/ST
2711195
11.2-13.2V DC
0.72W
Built-in main board
45 °C max. across the board
5
922502057_09_001
Warranty
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
info@olympia-electronics.gr
922502057_09_001
European
manufacturers
KLIN-20/ST
KLIN-20/ST
SELF TESTING MAINTAINED/NON-MAINTAINED
EMERGENCY LUMINAIRE
M
ΝΜ
Duration
Light output
IP44
Maintained
Non
1h/3h/8h
250/110/15lm
maintained
Thank you for your trust in our products
Olympia Electronics - European manufacturer

Advertisement

loading

Summary of Contents for olympia electronics KLIN-20/ST

  • Page 1 F: Automatic test gear complying with IEC 61347-2-7 denoted EL-T by Olympia Electronics or if the buyer modifies the goods provided or has any repairs or 60: 1 hour duration...
  • Page 2 charging mode and the Charge led starts to blink Package contents Indications LED Status Ceiling mounting until the batteries are fully charged. BATT. LAMP Luminaire CHARGE FAULT FAULT Automatic operational test (green) Wall mounting accessories (yellow) (red) Description Insert the This test includes all the operations that provide Ceiling mounting accessories cable grommet...