Network - NEC MultiSync ME431 User Manual

NETWORK

NETWORK MENU
NETWORK INFORMATION
IP SETTING
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
DNS
DNS PRIMARY
DNS SECONDARY
MAC ADDRESS
EXECUTE
NETWORK SECURITY
DISPLAY
COMPUTE MODULE
APPLY
PING
IP ADDRESS
EXECUTE
RESET
Configures the monitor's network settings either automatically or manually.
When [AUTO] is selected, the IP address is automatically obtained from the DHCP server.
When [MANUAL] is selected, the network settings must be entered manually. Contact the Network
Administrator for this information.


NOTE: Consult your network administrator for the IP address when [AUTO] is selected for [IP SETTING].
Set the IP address for the monitor connected to the network when [MANUAL] is selected for [IP SETTING].
Set the subnet mask data for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].
Set the default gateway for the monitor connected to the network when [MANUAL] is selected for
[IP SETTING].


NOTE: Enter [0.0.0.0] to delete the setting.
Set the IP addresses of DNS servers.
[AUTO]: The DNS server which is connected to the monitor will automatically assign its IP address.
[MANUAL]: Manually enter the IP address of the DNS server which is connected to the monitor.


NOTE: Consult your network administrator for the IP address when [AUTO] is selected for [DNS].
Enter the primary DNS server settings of the network connected to the monitor.


NOTE: Enter [0.0.0.0] to delete the setting.
Enter the secondary DNS server settings of the network connected to the monitor.


NOTE: Enter [0.0.0.0] to delete the setting.
Shows the monitor's [MAC ADDRESS].
Executes the network information settings.
Individually enable or disable the networking component for monitor functions.


NOTE: Please set "DISPLAY" to "ENABLE" when updating the firmware revision via the network.
Enables or disables the network function for controlling the monitor remotely.
When disabled, these functions do not work: External Control, Mail, HTTP server, SNMP, AMX, PJLink.
Enables or disables the network function for the Compute Module Interface Board only.
Apply the network security settings.
Confirm successful connection with the network by communicating with a preset IP address.
Sets an [IP ADDRESS] for sending [PING].
Checks a reply can be sent to the monitor or not from the [IP ADDRESS] by sending [PING].
Resets all network menu settings back to factory setting, except for [NETWORK INFORMATION] and
[PING].
English−85