Steelcase Workplace Advisor Installation Instructions Manual page 6

®
PLACE | Accessing Battery/Relocating Sensor
To access battery
1. Insert flat head screw driver into the slots to pry off mounting bracket cover (Figure 1).
2. Remove mounting bracket cover (Figure 2).
3. Slide sensor out of mounting bracket base (Figure 3); slide off rear housing to expose battery.
To relocate sensor
1. Insert flat head screw driver into the slots to pry off mounting bracket cover (Figure 1).
2. Remove bottom cover and slide sensor out of mounting bracket base (Figures 2 and 3).
3. Remove the screw.
4. Twist the mounting bracket base to remove from the worksurface (Figure 4).
5. Remove used adhesive tape and any residue and apply a new piece of adhesive tape before re-mounting.
6. Reposition and mount sensor in new location per instructions on previous page.
Figure 1 Figure 2 Figure 3 Figure 4
slots
Page 6 of 26
1125807001 Rev B