Power - Mark Levinson 5302 Owner's Manual

SETUP
Reload
Click to open a webpage that displays the N
configuration information.
Save
Click to save the webpage setup configuration settings.
Restore
Click to restore the amplifier to the factory settings. The unit
will enter the "green" Standby mode when the restoration is
complete. The amplifier will lose network connection after
this step. Use the front panel Standby switch to exit standby
mode and restore your network connection as outlined on
page 12.

POWER

Browser (BSP) method
Click Power to expand the menu and reveal the available
power management choices.
Standby: This setting lets you set the Standby mode to one of
the following options:
Green: This mode removes power from almost all of the
N 5302's circuits, allowing the unit to be activated only
0
via a wired IR control signal, a 5V – 12V trigger voltage
or a press of the Standby button. This mode provides
maximum power conservation and is the factory-default
Standby mode.
14 N 5302 POWER AMPLIFIER
0
/ OWNER'S MANUAL
Power Save: This mode removes power from the N
audio circuits but keeps the control circuitry powered and
5302's
0
ready to receive commands from any of the control inputs.
This mode provides moderate power conservation.
Normal: This mode mutes the amplifier's audio outputs
but keeps all of its control and audio circuits powered. This
mode provides the least amount of power conservation
but allows the audio circuits to remain warmed up to
deliver optimal performance at all times.
Auto Off: This setting lets you engage or disengage the
Auto Off function, which puts the N
mode after 20 minutes of inactivity (no audio signal, and
no user-control input).
Standby button method
Disconnect the amplifier's power cable from the AC mains.
Reattach the power cable while pressing and holding the
front-panel Standby button. Continue to hold the Standby
button until the Status LED flashes rapidly. The amplifier is
now in Standby Select mode. Each subsequent press of the
Standby button selects the next Standby mode:
• Rapid red flash: Green mode
• Rapid blue flash: Power Save mode
• Rapid white flash: Normal mode
To exit Standby Select mode, wait approximately ten seconds
until the Standby LED stops rapidly flashing. The amplifier
will enter Standby and save your selection. The Standby LED
will flash red, slowly.
5302's
0
5302 into the Standby
0