Mark Levinson 5302 Owner's Manual page 10

CONNECTIONS
USB port: This USB Type-A connector allows you to perform
firmware upgrades that may be offered in the future, and to
import and export setup configurations via a standard USB
drive or memory stick (FAT32 formatted). Firmware updates
may also be accomplished via download when the unit is
connected to a local area network (LAN) via an Ethernet
cable. (See page 13 for more detailed firmware update
instructions.)
IR input connector: This connector accepts IR (infrared)
control signals from other equipment.
See www.MarkLevinson.com for IR code data.
RS-232 port: This DB9F connector provides serial control
through a standard RS-232 protocol.
See www.MarkLevinson.com for RS232 code data.
Trigger output connector: This 3.5mm tip/sleeve connector
can be used to activate other components in the audio
system and listening room, such as amplifiers, lights and
window shades. A 12V 100mA DC signal is output whenever
the N 5302 is on. (See illustration below.)
0
Trigger input connector: This 3.5mm tip/sleeve connector
can be connected to the trigger output of another system
component or control system that supplies a trigger voltage.
Whenever the unit detects a voltage between 5V and 12V DC
at this connection it will turn ON. When the trigger signal
at this connection ceases the N
mode. (See illustration above.)
8 N 5302 POWER AMPLIFIER
0
5302 will enter the Standby
0
/ OWNER'S MANUAL
Ethernet port: This RJ45 jack supports connection to a home
network via Cat5e or Cat6 Ethernet cable and allows you to
access the Setup menu and other controls via a browser-
based setup panel.
AC mains connector: This connector provides AC power
to the N 5302 when the supplied power cord is connected
0
from it to an AC electrical outlet. This should be the LAST
connection you make in the hookup process.
We recommend that you unplug the unit from the AC wall
outlet during lightning storms and extended periods of
non-use.
Stereo/Bridged selector switch: Use this switch to select
Stereo or Bridged mode. The mode can only be changed
when the unit is in Standby . Please make sure the speakers
are wired correctly for the selected mode. The switch will
illuminate when the unit is on and set to bridged mode.