Step 5 Connect the Power Supply
The power supply specifications should match the physical
configuration of the chassis.
Make sure that the power switch is Off before installation.
Before attaching all components, make sure that the proper voltage
has been selected. Power supplies often can run on a wide range of
voltages, but must be set (usually with a switch) to the proper
range.
Use at least a 200 watt (or larger) power supply. It should have
built-in filters to suppress radiated emissions.
The power supply is connected to P2 and P3 on the motherboard.
The connectors should be keyed to prevent connecting the plugs to
the wrong connectors. The keys on the connector must be cut to fit
on some power supplies. See the following graphic.
Chapter 2 - Installation
22