Table of Contents
Advertisement
S t e p 5 C o n n e c t t h e P o w e r S u p p l y
S t e p 5 C o n n e c t t h e P o w e r S u p p l y
The power supply should match the physical configuration of the chassis. Make sure that the power switch is Off before performing
this step. Before attaching all components, make sure that the proper voltage has been selected. Power supplies often can run on a
wide range of voltages, but must be set (usually with a switch) to the proper range. Use at least a 200 watt (or larger) power supply,
which should have built-in filters to suppress radiated emissions.
AT-compatible power supplies have two six-pin connectors that are inserted in P1 and P2. The six-pin connector with three red wires
and two black wires is connected to P2 and the remaining 6-pin connector is connected to P1.
Chapter 2 - Installation
16
Advertisement
Chapters
Table of Contents
