Step 1 Set Switch And Jumper Options; Set Switch And Jumper Options - American Megatrends Super Voyager LC User Manual

Step 1 Set Switch and Jumper Options

Set all user-configurable jumpers and switches before installing the
motherboard. The Super Voyager LC has two switches and four
jumpers:
SW1 Cache Memory Size Select
SW2 DIAG and Display
J12 Processor Type
J17 Clock Select
J23 Power Good Signal Select
J33 CMOS Drain
SW1 Cache Select
SW1 is a four-position two-bit DIP switch. See the graphic on page
9 for the location of SW1. If all four switches are OFF, 64 KB of
cache memory is configured. 256 KB cache memory is configured
if all switches are ON.
SW2 Diagnostics and Color
SW2 consist of two switches. The diagnostic switch is used for
manufacturing diagnostics and should not be changed. The
motherboard is shipped with this switch OFF. The switch should
remain OFF.
The COL/MONO switch sets the type of video adapter card. This
switch has no effect if an EGA or VGA adapter is used. This
switch is factory-set to OFF for a monochrome display adapter.
Set ON for a color graphics adapter (CGA).
Super-Voyager LC Motherboard User's Guide