Installation Steps; Step 1 Set Switch And Jumper Options - American Megatrends Baby EISA User Manual

Installation Steps

Step 1 Set Switch and Jumper Options

Set all user-configurable jumpers and switches before installing the
motherboard in the chassis.
SW
SW is a dual two-position DIP switch. SW-1 (DIAG) is OFF when shipped
and it should remain OFF. The COL/MONO (SW-2) switch sets the type of
video adapter card in the system. This switch is factory-set to OFF, for
a monochrome display adapter (MDA ). Set ON for a color graphics
adapter (CGA). This switch has no effect if an EGA or VGA adapter is
installed. SW is in the same end of the motherboard as the CPU but in
the opposite corner. See the figure on page 15.
American Megatrends 80486 Baby EISA Motherboard User's Guide
Step
1 Set switch and jumper options
2 Install memory
3 Install upgrade processor
4 Install motherboard
5 Connect the power supply
6 Connect the keyboard
7 Connect the mouse
8 Connect cables
9 Install adapter cards
10 Test and configure
The Baby EISA motherboard contains sensitive electronic
components which can be easily damaged by static electricity.
Follow the instructions carefully to ensure correct installation
and to avoid static damage.
Action
Warning
Turn to
Page 13
Page 16
Page 18
Page 19
Page 20
Page 24
Page 25
Page 26
Page 28
Page 33
13