Maico MA 33 Operation Manual page 70

If there was no response at all, a question mark appears automatically in the table. This
question mark appears also, when the examiner clicks the No-answer-button or the ?-key
on the keyboard.
Figure 103
The level at which the patient correctly understood the sentence is shown on the display.
This level is saved under Test result beside the respective ear and is displayed on the
screen (Figure 77). Instead of the picture board you can also use a touch screen. You
can get to the touch screen by clicking on the button 2nd Monitor (Figure 76). It allows
answering the test questions by touching the right picture on the screen.
If the little patient touches the correct picture, a green check mark appears
in the table.
If the patient touches the wrong picture, a red cross is displayed.
If the child does not touch a picture at all, a question mark is displayed in the
table.
Figure 104
The test continues after the confirmation of the examiner (correct/incorrect). You can
change the pause length between the sentences by selecting the pause length from the
drop down menu Interval (3 s to 20 s or Correct/Incorrect) in the Speech test start
screen (Figure 105 and Figure 106).
Activating the option Response while presenting allows for confirmation during the
presentation of words.
8100092 Rev. 9
The test will go on to the next sentence „Where is the car?"
and the volume level decreases to 60 dB HL. The next
picture is displayed on the screen. The test will continue with
the next words of the Group 1 and decreasing levels.
The results are shown in the table (Figure 103).
Choose a different test group for the second ear, so that the
patient does not get too familiar with the test. Do this by
clicking on the correspondent Group button (Figure 104).
There are four different groups of test words/sentences
at your disposal.
Operation Manual MA 33
68 19/08/2019