Table of Contents
Advertisement
Step 7 Attach Connectors,
J15 VGA Connector J15 is a standard DB15 VGA connector for the onboard ATI Rage II PCI
VGA controller is in the I/O connector block. The onboard VGA is enabled by
default. You can disable the onboard VGA by placing a jumper on J23. Connect
a VGA monitor to this connector via a standard VGA cable. The pinout for the
standard female DB15 VGA connector is shown below:
Pin 6 Ground
Pin 1 Red
Pin 7 Ground
Pin 2 Green
Pin 8 Ground
Pin 3 Blue
Pin 9 Fuse
Pin 4
Pin 5 Ground
Standard VGA Female Connector
J31 Turbo LED J31, Turbo LED (light-emitting diode) is not connected.
J32 External Reset J32 is a two-pin single-inline berg that is attached via a cable to an externally-
mounted reset switch. When the reset switch is pressed, the system performs a
hard reset. Pin 2 is Ground and Pin 1 is Hard Reset.
Continued
Pin 11
Pin 12 MONID1
Pin 13 HSYNC
Pin 14 VSYNC
Pin 15 MONID2
Pin 10 Ground
Chapter 1 Hardware Installation
Cont'd
37
Advertisement
Table of Contents
