Table of Contents
Advertisement
Step 1 Unpack the Boards
The Megaplex system includes the following components:
AMI Part
Number
Series 769
Series 770
Series 776
Series 777
Series 778
Step
1
Inspect the cardboard carton for obvious damage. If damaged, call 770-
246-8645. Leave the motherboard in its original packing.
2
Perform all unpacking and installation procedures on a ground-
connected anti-static mat. Wear an anti-static wristband grounded at the
same point as the anti-static mat. Or use a sheet of conductive
aluminum foil grounded through a 1 megohm resistor instead of the
anti-static mat. Similarly, a strip of conductive aluminum foil wrapped
around the wrist and grounded through a 1 megohm resistor serves the
same purpose as the wristband.
3
Inside the carton, the boards are packed in an anti-static bag, and
sandwiched between sheets of sponge. Remove the sponge and the
anti-static bag. Place the boards on a grounded anti-static surface
component side up. Save the original packing material.
4
Inspect the boards for damage. Press down on all ICs mounted in
sockets to verify proper seating. Do not apply power to the board if it
has been damaged.
5
If the boards are undamaged, they are ready to be installed.
Set Jumpers
Set all jumpers and install the CPU before placing the motherboard in the
chassis.
Description
CPU board
I/O board
Three (3) CPU termination cards
Memory expansion card (if ordered)
Memory termination card (if the 777 card is not ordered)
Action
Chapter 1 Hardware Installation
9
Advertisement
Table of Contents
