American Megatrends Baby EISA User Manual page 78

Hard Disk Utility Error Messages,
Operation Errors
72
Chapter 4 AMIBIOS Setup
Continued
Message
Address Mark Not The address mark (initial address) on the hard disk
Found could not be found.
Attachment Failed to No response from the hard disk drive.
Respond
Bad ECC on Disk When the hard disk drive utility writes to the disk, it
Read also calculates an ECC (Error Correction Code)
value for the data being written. This ECC value is
written to the drive and then read back. The value
read back is different from the one calculated.
Bad Sector Flag An operation was performed on a sector flagged as
Detected bad.
Controller Has A diagnostic command issued to the controller failed.
Failed
Drive Not Ready An operation on the hard disk drive timed out. The
hard disk drive utility waited beyond a preset
specified time limit.
Drive Parameter A reset command was sent to the controller followed
Activity Failed by drive parameters. Using these parameters, the
controller did not get a response from the hard disk.
Make sure the drive type is correct.
ECC Corrected Data The ECC value (explained above) read from the disk
Error is not the same value written to the disk. The data is
not correct. An attempt was made to correct the
data, but the ECC value is not corrected.
Requested Sector The requested sector could not be found.
Not Found
Reset Failed The reset command did not properly reset the hard
disk.
Seek Operation A seek command failed. A seek operation is the act
Failed of finding a particular sector on the hard disk.
Undefined Error - An unidentifiable error condition occurred.
Command Aborted
Write Fault on A write fault occurred during the write operation on
Selected Drive the hard disk drive.
Explanation