Table of Contents
Advertisement
Reprogramming from System Boot,
Beep Codes
During normal operation, the Flash utility produces a series of beeps to:
•
signify completion of a step (as shown on the previous page), or to
•
signal an error.
Error beeps are arranged in a coded sequence and have different meanings depending on when they occur.
The following list describes the error beep codes and when they can occur.
Step
—
1
2
3
4
5
6
7
9
Chapter 6 Flash ROM Programming
40
Continued
Beeps
None
Successful completion.
Continuous
There is no floppy disk in Drive A:.
Single Beep
Five Beeps
S717P.ROM is not present in the root directory of the
floppy disk in the A: drive.
Seven Beeps
Floppy Read Error.
Six Beeps
BIOS File Size Error.
Eight Beeps
An Intel i28F001BX-T Flash EPROM is not present.
Continuous
There is a problem in erasing the Flash EPROM.
Two Beeps
Continuous
There is a problem in programming the Flash EPROM.
Three Beeps
Continuous
The BIOS is not able to reset the CPU.
Four Beeps
Description
Advertisement
Table of Contents
