Step 2 Set Jumpers,
J2 Display Type J2 is a two-pin single-inline berg.
Short pins 1-2 of J2 if using a CGA monitor.
Leave J2 OPEN (the factory setting) if using a monochrome, EGA, or VGA monitor. See the drawing on page
16 for the J2 location.
J4 Flash ROM Power J4 is a three-pin berg that selects the type of power provided to the Flash ROM.
Short pins 1-2 to select +12V.
Short Pins 2-3 to select +5V (the factory setting). See the drawing on page 16 for the J4 location.
J12 Hardware Reset J12 is a two-pin single-inline berg. Short J12 to reset the system.
J3 CPU Pipeline Mode J3 is a two-pin single-inline berg.
Short J3 to enable CPU pipeline mode (factory setting).
Leave J3 OPEN to disable CPU pipeline mode. See the drawing on page 16 for the J3 location.
20
Continued
Apollo Motherboard User's Guide
Cont'd