Malfunctions - Siemens iQ300 User Manual

en Troubleshooting
Fault
Machine Care indicator
lights up.

Malfunctions

Fault
Water is left in the appliance
at the end of the pro-
gramme.
Appliance cannot be
switched on or operated.
Appliance does not start.
Programme starts automat-
ically.
Appliance stops during the
programme or cuts out.
56
Cause
Machine care is recommen-
ded.
Cause
Filter system or area under
the filters is blocked.
Programme has not yet
ended.
Appliance functions have
failed.
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed
properly.
You did not wait until pro-
gramme ended.
Appliance door is not closed
properly.
Power and/or water supply
has been interrupted.
Troubleshooting
Run the Machine Care programme
▶
without tableware.
Use a special machine care
‒
product.
The indicator will go out automatic-
ally after 3 wash cycles whether
Machine Care is carried out or not.
Troubleshooting
Clean the "Filters" → Page 43.
1.
Clean the "Wastewater pump"
2.
→ Page 58.
Wait until the programme ends or
▶
cancel the programme with reset.
→ "Terminate programme",
▶
Page 38
Pull out the mains plug or switch off
1.
the fuse.
Wait at least 2 minutes.
2.
Connect the appliance to the power
3.
supply.
Switch the appliance on.
4.
Check the relevant fuse.
▶
Check whether the socket works.
1.
Check whether the mains cable is
2.
properly inserted in the socket and
on the rear of the appliance.
Close the appliance door.
▶
→ "Terminate programme",
▶
Page 38
Close the appliance door.
▶
Check the power supply.
1.
Check the water supply.
2.