Siemens iQ300 User Manual page 50

en Troubleshooting
Fault
Tableware is not dry.
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet
after wash cycle.
Remnants of food on table-
ware.
50
Cause
Tableware removed too
early or drying process not
yet ended.
Rinse aid used has a limited
drying performance.
Appliance door does not
open automatically at the
end of the Eco 50° pro-
gramme
Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
Tableware was placed too
close together.
Basket is overfilled.
Spray arm rotation is
blocked.
Spray arm nozzles are
blocked.
Troubleshooting
Wait until the programme ends.
1.
Only remove tableware 30 minutes
2.
after the programme has ended.
Use a name-brand rinse aid.
▶
Eco products may have limited ef-
fectiveness.
Adjust the appliance door as de-
▶
scribed in the installation instruc-
tions.
The door gap must be at least
70 mm - 100 mm.
No remedial action possible.
▶
Arrange the cutlery properly.
1.
→ "Arrange tableware", Page 36
Arrange cutlery individually where
2.
possible.
Avoid points of contact.
3.
No action required.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware so that it does
▶
not obstruct spray arm rotation.
Clean the "Spray arms" → Page 44.
▶