Install/Removal Tool For Base With I/O Board - American Dynamics SpeedDome Ultra VII EIS Installation And Service Manual

Twisted Pair Adapter
Figure 8. Twisted Pair Adapter
The supplied ADACTP01BNC Twisted Pair
Adapter (Figure 8) is used to transmit video or
video with UTC (up-the-coax) dome control signals
over unshielded twisted pair (UTP) cables, point-to-
point, up to 300m (1000ft).
The adapter mounts directly to the video source or
receiver without additional cabling and uses
Category 2-6 twisted pair wires to transmit the
video and dome control signals. The adapter does
not require power.
One adapter is supplied. If used, another adapter
must be ordered for the connection at the other
end of the cable. Figure 9 shows twisted pair cable
connections. See installation guide 8200-0298-01
for details.
Figure 9. Cabling overview
American Dynamics
Dome or
Fixed Camera
Cat 2-6 UTP Cable
Video Switcher/
Controller
SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME
INSTALLATION AND SERVICE GUIDE
Twisted Pair Adapter
(Dome End)
Twisted Pair Adapter
(Fixed Camera End)
Twisted Pair Adapter
(Switcher/Controller End)
8 of 37
Install/Removal Tool for Base
with I/O Board
The install/removal tool (Figure 10) enables you to
connect or disconnect the housing and eyeball
assembly from the base with I/O board, and to
attach/detach skirts and bubbles to a top-hat
housing, without the need for a ladder. The tool
attaches to a telescopic pole (purchased
separately). See page 20.
CAUTION: Do not use this tool to connect the
dome to the base without I/O board.
Figure 10. RHIRT indoor install/removal tool
RHIRT Removal Tool
Telescopic Pole 08140
by Recreational Water
Products. See page 20
to order.
8200-0184-14, REV. A