Data Cable Requirements; Install/Removal Tool For Adiob Base - American Dynamics AD715LS Series Installation And Service Manual

Data Cable Requirements

Table 2 shows the data cable requirements for
SensorNet, RS422, and Manchester networks. For
more information about communication protocols
and cable networks, see Communication Protocols
and Cable Networks, 8000-2573-19.
Table 2. Data cable requirements
SensorNet
Cable 1
type unshielded,
twisted
pair*
Wire 22 AWG
gauge
Con Non-
nection polarized
Max. 32
devices
on line
* Power, data, and video cables can be ordered
separately or within a composite cable that can be
ordered in various lengths. Plenum-rated cables
must be used in indoor ceilings used for environ-
mental air return (called "other air space" in the
National Electrical Code). Order parts through
your distribution network.
Note: If you order cable from an outside
source, wire colors may be different.
** Belden 88760 (plenum), or Belden 8760 cable
(non-plenum) cable is recommended. Plenum-
rated cables must be used in indoor ceilings used for
environmental air return (called "other air space" in
the National Electrical Code). Order
from Belden by calling 1-800-235-3361.
INSTALLATION AND SERVICE GUIDE
RS422 Manchester
2 1
shielded, shielded
twisted twisted pair**
pair*
22 AWG 18 AWG
Polarized Polarized
10 3
cable directly
Install/Removal Tool for
RUIOB Base
The install/removal tool (Figure 9) enables you to
connect or disconnect the housing and eyeball
assembly from the RUIOB base with I/O board,
and to attach/detach skirts and bubbles to a top hat
housing, without the need for a ladder. The tool
attaches to a telescopic pole (purchased
separately). See page 20.
CAUTION: Do not use this tool to connect the
dome the RUPTB base.
Figure 9. RHIRT indoor install/removal tool
RHIRT Removal Tool
Teslescopic Pole 08140
by Recreational Water
Products. See page 20
to order.
8
DeltaDome II Camera Dome
8000-2708-01, REV. B