Safety Considerations; Unit Parts And Dimensions; Electrical Requirements - Field Controls VentCool 1.7 Installation Manual

SAFETY CONSIDERATIONS

Some of the principles of this product's safe installation and operation are not immediately Some of the principles of this product's safe installation and operation are not immediately
obvious. Read the following safety information before continuing further: obvious. Read the following safety information before continuing further:
• Never operate this fan without a window or door opened.
• This fan is meant for general ventilation. It has NOT been designed to ventilate particle laden and/or
explosive mixtures of air. explosive mixtures of air.
• • This fan is This fan is NOT NOT for use in kitchens.
• Never force open the damper doors, this could severely damage the actuators. Always use the yel-
low clutch releases located on the actuators before attempting to manually open or close the damper
doors.
• Before installing or servicing this fan, switch power off at the home's electrical panel to reduce the risk of
damaging circuit board, fi re, electrical shock, or injury.
• Install this fan in accordance with this manual and all local codes and standards.
• There is a risk of injury from the fan blades, if people or animals are expected to be in close proximity to
an operating fan. If this situation may occur, do not operate the fan without a fan guard. Contact Field
Controls technical support for more information.

UNIT PARTS AND DIMENSIONS

ELECTRICAL REQUIREMENTS

The VentCool 1.7™ model requires a 120 volts, 2 amp, uninterrupted power supply. These specifi cations must be tak- The VentCool 1.7™ model requires a 120 volts, 2 amp, uninterrupted power supply. These specifi cations must be tak-
en into account when allocating power from existing circuits. We strongly recommend providing a dedicated circuit. en into account when allocating power from existing circuits. We strongly recommend providing a dedicated circuit.
This fan has a factory-installed, 10 ft. power cord. Consider this length when choosing a location for this unit.
Depending on the location of existing outlets in the attic, the installation of an additional outlet may be required.
Consult an electrician if necessary.
All wiring and connections must be made according to this manual and acceptable wiring standards. All local
codes must be followed.
P/N 78010008000 05/19 Rev B
for use in kitchens.
page 2 of 8
It has NOT been designed to ventilate particle laden and/or